88
Section 6: Electrical System
The shore line power cord should be unplugged when the recreation vehicle is left
unattended. If something would happen to the electrical system, this may help limit
potential damage.
When you are ready to leave, reverse the power cord connection process. Use care to pre-
vent damaging the power cord electrical connection pins when connecting or disconnecting
the shore line power cord. Grasp the plug to remove the power cord from the outlet; do not
unplug it by pulling on the cord.
Maintenance
Inspect the power cord for cuts, cracks and worn insulation. Have the power cord replaced
immediately if these symptoms are noticed.
Inverter (if so equipped)
A factory installed inverter converts 12-volts DC to useable 120-volts AC and supplies con-
tinuous AC power to the appliance plugged into it. It is important that you familiarize your-
self with the inverter function and operation. The inverter should be “off” when not in use.
The factory-installed inverter is not intended for use with medical device(s).
If your recreation vehicle is equipped with a residential style refrigerator, the inverter may
be used to supply the 120-volts AC necessary to power the refrigerator.
Maintenance
There are no customer serviceable parts inside the inverter case and the manufacturer’s
warranty will be void if the case has been removed
. The inverter cooling fins and the cooling
fan should be kept clear of any obstructions.
Your RV may have an inverter remote display like this one on
the Command Center switch panel. There are power and select
buttons, Status/Display indicators and a single line digital alpha
numeric display. The display can show measured battery volt-
age, AC output power, inverter settings and error codes.
POWER
button is used to turn the inverter on and off. To turn
on the inverter and the LED display press and hold
POWER
for
1 second until you hear a beep.
The
STATUS
and
DISPLAY
indicators indicate the inverter status:
•
STATUS & DISPLAY LEDS - both GREEN - Unit is plugged into shore power. The
panel is in
Bypass Mode
and will display battery voltage in DC volts.
•
STATUS LED AMBER, DISPLAY LED GREEN -
Inverter Mode
is active. Inverter
is ON and will display battery voltage in DC volts. (Not connected to shore power)
NOTE:
When in
Inverter Mode
you will be able to cycle through
Battery Voltage, Inverter Power, inverter settings and error codes.
When in
Bypass Mode
you will be able to cycle through Battery
Voltage, inverter settings and error codes. Inverter Power will not be
available because the inverter is idle.
Maintenance Record
Table of Contents
Содержание PINNACLE FIFTH WHEELS 2019
