Jayco PINNACLE FIFTH WHEELS 2019, Руководство пользователя

Страница: 59 / 185

57
Section 4: Vehicle Operation
Raising and lowering the hoist
The crank handle to raise and lower the tire will be located (fastened to the sidewall) in a
basement compartment of the recreational vehicle. Insert the crank handle into the crank
access port located either in the center of the rear bumper, or on the sidewall of the RV. Turn
the crank handle to raise/lower the tire. Two “crisp breaks” must be heard and felt to insure
the proper seating of the tire for travel.
Securing the spare tire
To secure the spare tire in the travel position, put the steel hoist lift support located on the
end of the cable through the rim of the tire. The hoist lift support clips need to seat inside
the center hole of the tire rim. The valve stem of the tire MUST be pointed up (toward the
bottom of the RV).
Bumper Mount
The spare tire bracket can be released and extended down to access a storage compartment
at the rear of the trailer without removing the tire.
To extend the tire down
1. Remove the cotter key from the pin holding the tire
carrier in place.
2. Remove the pin and extend the carrier away from
the trailer.
Always return the tire carrier to the upright position
and lock it in place while traveling.
To remove the tire from the tire carrier
1. Remove the lug nuts holding the tire in place.
2. Remove the support bracket from the bottom lug.
3. Pull the tire from the tire carrier.
To install the tire on the tire carrier
1. Place the tire on the carrier with the top lug bolt inserted into one of the holes in the tire
rim and the bottom lug bolt in the center of the rim.
2. Install the top lug nut.
Crank Access Port
NOTE: If the manual crank access port is
located in a slideout, the slideout room must
be in the travel position to allow the crank to
reach the mechanism used to raise or lower
the tire.
Table of Contents Maintenance Record