Jayco PINNACLE FIFTH WHEELS 2019, Руководство пользователя

Страница: 51 / 185

49
Section 4: Vehicle Operation
Dexter EZ Flex Equalizer (if so equipped)
Your recreation vehicle may be equipped with the Dexter EZ Flex
Equalizer suspension. This includes heavy-duty shackles and wet
bolts. Wet bolts have a grease zerk attached to the head of the bolt,
and a hollow channel inside going to a single hole in the middle
of the bolt. A brass sleeve (or bushing) slides over the bolt. As
grease is pumped into the bolt, it exits through the hole in the bolt
lubricating the brass bushing. This improves suspension wear and
greatly reduces the chances for failure of the shackles and bolts.
Maintenance
Wet bolts should be greased approximately every 3500 miles.
Stabilizer Jacks
The stabilizer jacks must be fully retracted before moving or towing the RV to prevent
stabilizer jack damage.
Each stabilizer jack can be individually adjusted to stabilize the RV for use.
When setting up on soft ground, you may wish to place a wood pad or the equivalent under
each stabilizer jack foot to help keep the jack from sinking into the ground.
Manual Stabilizer Jacks (if so equipped)
1. To lower each jack, insert the jack crank onto the applicable stabilizer jackshaft.
2. Turn the crank clockwise to lower each leg until it contacts the ground and stabilizes
the RV.
To raise each jack, insert the jack crank onto the applicable stabilizer jack shaft and turn the
crank counter-clockwise.
Electric Stabilizer Jacks (if so equipped)
Control switches for the stabilizer jacks are typically located on the (door) side of the unit
above the stabilizer jack(s).
To lower each jack, press the control switch until each leg contacts the ground and stabilizes
the unit.
To raise the jack, press the control switch until the jack is returned to the retracted position.
Manual Override:
The electric stabilizer jacks may have a built in manual override system. The override
coupler is located on the end of the stabilizer jack opposite the electric motor. One of the
wire motor leads must be disconnected to prevent back loading the motor and causing more
damage.
DO NOT USE THE STABILIZER JACKS TO LEVEL THE RV.
It is important to remember that the stabilizer jacks are to be used only for
support while occupying and moving around the RV. They are not designed to
support the weight of the RV.

Table of Contents Maintenance Record