132
Section 8: Plumbing System
Toilet
Prior to using the sanitation system, it is strongly recommended to flush the toilet several
times to release sufficient water into the holding tank. Generally, more water is required only
when flushing solids.
The toilet system will perform better when water is run for ten to fifteen seconds after flush
-
ing to ensure that the waste will proceed to the bottom of the tank.
If there is not a sufficient amount of water used during flushing, the waste materials may
not evacuate properly from the drain line to the tank. Clogged tanks and pipes could eventu-
ally occur. For added convenience and better sanitation system performance, it is advisable
to always have four to six inches (10 - 15 cm) of water in the toilet. It is important to add
It is important to prevent solid waste buildup. Follow the toilet manu-
facturer’s recommended instructions each time after emptying the black
water holding tank.
To help prevent toilet blockage, always use RV grade single-ply toilet pa-
per. Do not flush paper towels, diapers, sanitary napkins or other foreign
objects down the toilet.
Do not use chlorine (undiluted) or caustic chemicals, such as laundry
bleach or drain opening types, in the toilet system. These products dam-
age the seals in toilets and dump valves.
The tank heater switch should be turned ON:
When liquid is present in the holding tanks and the outside temperature approach-
es and maintains freezing conditions 35°F (2°C) or colder.
The tank heater switch should be turned OFF:
When there is NO liquid present (tanks are empty).
When dumping the black and gray holding tanks and the drain pipes.
When fresh water tank and supply lines are empty or being drained for storage.
When the recreation vehicle is connected to city sewer and the gate valves are
open.
Free draining is never recommended, especially in cold weather use.
When ambient temperatures rise and remain above freezing.
No maintenance on the heaters is required, only a periodic inspection for loose wires, dam-
age, etc. For additional detailed information, refer to the tank heater manufacturer’s user
guide.
•
In order for the 120VAC tank heaters to be in operation, the recreation
vehicle
MUST
be hooked up to shore power or under generator power.
•
If the recreation vehicle is not operating on shore power or generator
power,
only the +12VDC heaters will operate. This can result in the
tanks freezing.
•
The red light on the command center tank switch does not necessarily
indicate that
ALL
heaters are operating; it is a only a warning that the
heater circuit is ON.
Table of Contents
Содержание NORTH POINT 2023
