Jayco Hummingbird Towables 2019, Руководство пользователя

Страница: 62 / 165

Section 4: Vehicle Operation
60
Emergency Operation
If power to the vehicle is not available, the awning can be
retracted by jumping the motor using a 10VDC – 14VDC
power source such as a cordless drill battery or car battery.
1. Remove the front cover (the cover snaps onto the rear
cover). Press on both sides of the rear cover until the
front cover releases then lift the cover off.
2. Detach the RED and BLACK wires from the cable
to the motor.
3. Attach jumper wires to the motor wires.
4. Connect the other ends of the jumper leads to the 10VDC – 14VDC source. If the
awning moves in the wrong direction, reverse the leads. Maintain contact throughout
the retraction process.
5. When the awning is closed, remove the jumper wires and reattach the cable wires to the
motor wires. Be sure to match RED to RED and BLACK to BLACK.
6. Snap the front cover onto the rear cover. Hang the cover on the top and swing it down
until it clicks.
Carefree® Travel’r Awnings (if so equipped)

Press the power switch to ON. The Direct Response system is activated and man-
ual controls are active. All functions are disabled if the switch is off.

Press and hold the EXTEND switch to open the awning.

Press and release the RETRACT switch. The awning will close completely. To
interrupt retraction, press and release the RETRACT switch again.

When the awning is retracted turn the power switch OFF.
Power switch should be set to OFF whenever the awning is not being operated
and during transport.

DO NOT USE A 110VAC POWER SOURCE FOR THE EMERGENCY
OVERRIDE PROCEDURE! Doing so will permanently damage the awning!
Do not use the Emergency Override without following the directions.

NOTE: If the awning is equipped with the Direct Response system,
this procedure is not applicable. See the manufacturer’s owner’s
manual for additional information.
Table of Contents Maintenance Record