Jayco Greyhawk, Руководство пользователя

Страница: 53 / 134

Non-Basement Models
Two methods of winterizing your motorhome after draining and flushing the system are listed
below.
USING THE WATER HEATER BYPASS
The water heater bypass is available on most
vehicles.
1. Turn off the pump.
2. Make sure the valves are set in one of the
following ways:
Model 23 RK : Close valves 1, 2, 3, 4 and
5 and open valve 6. (Fig. 4-31 & 4-32)
Model 24 SS : Close valves 1, 2, 4 and 5
and open valves 3 and 6. (Fig. 4-33)
3. Drain the water heater (Consult the water
heater owner's manual for details.) and
fresh water tank.
4. Put the clear hose into a jug of non-toxic
RV antifreeze. You will need more than
one gallon of antifreeze.
5. Turn on the pump and open each faucet until the antifreeze flows
through. Do not forget to run the antifreeze through the toilet.
6. Pour at least one cup of antifreeze into each
drain to protect the P-traps.
7. Before using the water system again, drain
(see the draining instructions in this chapter)
and flush the water system. Sanitize (see the
sanitizing instructions in this chapter) and
flush the whole system. It is now ready for
use.
USING AIR PRESSURE
1. Run the pump until dry, about fifteen
seconds.
2. Make sure the valves are set in one of the
following ways:
Model 23 RK: Close all the valves. (Fig.
4-31& 4-32)
Model 24 SS: Close valves 1, 2 and 3.
Open valves 4, 5 and 6. (Fig. 4-33)
I
CAUTION: If the above step is not followed, air pressure will fill the potable water tank
which could cause serious damage to the tank.
3. Using an air hose and adapter, blow air through the city water fill. (Fig. 4-4)
4. Leave the faucets, drains and toilets open. Any remaining water will blow out in five to ten
minutes.
5. Pour one cup of non-toxic RV antifreeze into all drain P-traps.
The Systems 45
1 & 2 - Low Point Drains
3 - City Water
4 - TankFill
5 - Pump
Operation
6 - Winterize
Fig. 4-33
1 & 2 - Low Point Drains
3 - TankDrain
4 - TankFill
5 - TankOutlet
6 - Winterize
7 - City Water
Fig. 4-31
Fig. 4-32