Jayco Greyhawk 2018, Руководство пользователя

Страница: 53 / 169

43
Section 4: Vehicle Operation
After adjusting the front driver’s seat, adjust the outside rearview mirrors to your driving
preference. Have someone help you adjust the mirrors in the desired direction for maximum
rear visibility before driving. During travel, vibration may loosen the fitting holding the
mirror(s), causing them to change position. As part of your regular motor home maintenance,
check and adjust the mirrors to the desired position.
Power remote mirrors (if so equipped)
You can adjust the power remote mirrors when the ignition key is in the ON position.
1. Move the control knob to the side you want to adjust.
2. Press the control arrows in the direction you want the mirror to move.
3. Return the control knob to the center to lock the mirror(s) into place.
The power remote mirrors also contain heating elements to defog or de-ice the mirrored
glass if needed. To activate this feature, use the “Mirror Heat” control located on the driver’s
side console next to the mirror control.
Rear Vision Camera
The rear vision monitor gives a limited televised view of what is behind your motor home.
The rear vision camera will aid you in backing up the motor home, and can be used for a
greater field of vision when driving in heavy traffic.
Your RV may also be equipped with side view cameras mounted on each side of the RV
(facing rearward) to give you views down each side of the motor home. Check the outside
rear view mirrors when driving and backing for a more complete field of vision.
The monitor is operational whenever the engine is running. To use the monitor, flip the
switch from standby to ON (the monitor will also work when with the motor home is in
“reverse” and the monitor in standby). Make sure you turn the monitor to standby while
driving to avoid being distracted.
Never operate the rear vision monitor in the ON position for extended periods of time as this
may result in an “image burn” on the monitor.
For detailed operating and safety information, refer to the manufacturers user guide.
Camera/monitor system aids in the use of, but does not replace
vehicle side/rear-view mirrors.
Objects in camera/monitor view are closer than they appear
. When
backing up, proceed cautiously and be prepared to stop.

Campsite Hook-Up
Refer to Electrical Systems section before connecting the shore line power cord (when
using full hook-up) OR before starting the generator (if so equipped) or operating the
vehicle on 12-volt power when dry camping.
Refer to
Fuel & LP System section before using the LP system.
Open the LP gas tank
valve (if so equipped) slowly. There may be air in the lines and five to thirty seconds
of time is needed to bleed air before LP vapor fills the lines .
Refer to Plumbing Systems section before connecting the fresh water supply or turning
ON the water pump or water heater.
Table of Contents Maintenance Record