Jayco Greyhawk 2018, Руководство пользователя

Страница: 152 / 169

142
Section 12: Interior
Solid surface countertops (if so equipped)
Soapy water, ammonia based cleaners (not window cleaners as they can leave a waxy build
up that may dull the surface) or commercially available solid surface cleaners will remove
most dirt and residue from all types of finishes. A damp cloth followed by a dry towel will
remove watermarks.
Difficult stains can be removed from the matte finish with a green Scotch Brite® pad and a
mild abrasive cleaner. Disinfect the surface periodically with diluted household bleach (one
part water to one part bleach).
For cuts and scratches, sand the matte finish lightly with (220) fine grit sandpaper until
the cut or scratch is gone. Restore finish with a green Scotch Brite

pad and mild abrasive
cleaner.
Run cold water when pouring hot/boiling water into the sink.
Solid surface sink maintenance
Occasionally, clean the solid surface sink by filling one-quarter full with a 50/50 water/
bleach solution. Let soak for 15 minutes, and then wash sides and bottom of sink as solution
drains.
Flooring
Always test a cleaning agent in an inconspicuous area for colorfastness.
Carpet
Vacuum your carpet regularly. It is important to remove loose soil and debris while it is on
the surface. Heavily traveled areas (i.e., walkways, areas in front of the furniture) may be
protected with small throw rugs to prolong the life of the carpet.
Prompt attention to spots and spills is essential. Remove as much of the spill as possible.
Absorb wet spills as quickly as possible by blotting repeatedly with white paper or cloth
towels.
Refer to the manufacturer’s guide for detailed cleaning information, or contact a cleaning
professional.
Vinyl flooring
Periodically vacuum or sweep to remove dirt and gritty particles. Although most common
spills will not permanently stain the vinyl floors, they are usually easier to remove if wiped
up before they set. Blot with a paper towel and wipe clean with a damp cloth. Do not use
dish detergents or vinegar and water because they will dull your floor.
To care for the vinyl floor covering, use a damp mop with water and a mild cleaner on
the entire floor. DO NOT SOAK THE FLOORING. Use care to avoid wetting the carpet
edges. To avoid problems of “yellowing” linoleum, the flooring manufacturer recommends
avoiding cleaners that contain oil based solvents (i.e. lemon oil, Murphy’s Oil Soap, etc.).
Privacy Drape Installation
1. Starting on the driver’s side, attach the black plastic hook to the loop on the wall
(behind the driver’s seat). Make sure the Velcro® on the drape is facing the motorhome
windshield.
2. Pull the drape towards the windshield and past the driver’s side sun visor. Open the sun
visor against the windshield to hold the drape in place.
3. Continue across the windshield to the passenger side, again opening the sun visor and
placing the drape behind it.
Table of Contents Maintenance Record