Jayco Greyhawk 2018, Руководство пользователя

Страница: 114 / 169

104
Section 8: Plumbing System
Once activated, the water pump (also known as the demand pump) will self-prime,
and provide water. The pump is designed for
intermittent use only.
Using the pump
continuously or with high pressure will shorten the life of the pump and is not covered in
your warranty.
Periodically check the in-line water pump strainer for accumulated debris. To clean, shut off
the water pump, unscrew the clear cap, remove the re-useable metal strainer and clear any
debris, then reinstall.
For additional information on the care and operation of the pump, read the safety and
operating information in the pump manufacturer’s owner’s manual.
Water Pump Switch (if so equipped):
Most water pump switches illuminate when the
water pump is activated. In most models, the (red) pump switch is located on the monitor
panel or the utility center. When the water pump switch is ON the pump runs until 45 lbs.
of pressure has been achieved. The red light will stay on. The water pump automatically
recycles when pressure drops. Some cycling may occur depending on the volume of water
being released. Turn the water pump switch OFF when it is not in use.
The water pump switch should be in the OFF
position when the RV is left unattended for any
amount of time. If something would happen to the
water system, this may help limit water damage to
a smaller area.
NOTE: In some models the water pump switch will be a black rocker
switch located near the sink cabinet
Water Purification System (If So Equipped)
If equipped with a water purification system:
If the water supply has not been used for some time, allow the water to flow for several
minutes to flush the system.
Filters should be replaced at the beginning of each camping season or if they have
come into contact with contaminated water.
When not in use, the water filter cartridge should be stored out of freezing temperatures.
RV antifreeze will damage the water filter cartridge.
Filter canister is typically located in a compartment behind the utility center.
To Replace Canister Filter Cartridge
1.
Turn off water supply using two valves located on the water lines on each side of the
canister. Water pump should be OFF.
2.
Place drip pan below filter housing to catch any spillage.
3.
Press the red button on top of the filter housing to release pressure.
4.
Using a spanner wrench, rotate the filter housing. Unscrew the housing completely,
dump water out and remove the filter (dispose of the old filter properly.
Table of Contents Maintenance Record