Jayco Granite Ridge Greyhawk Escapade 2005, Руководство пользователя

Страница: 94 / 112

.
NOTE: A road test by the independent, authorized dealer should be included as part
of the pre-delivery inspection. The independent, authorized dealer can then arrange
to have any steering problems corrected before you take delivery of the
motorhome. After this road test has been completed, front-end alignment and/or
vibrations will not be covered as part of the new vehicle limited warranty.
WHEEL LINERS
Your motorhome may be equipped with Versa-Liner® Wheel Liners. Information on the
function of these liners is supplied with your unit by the wheel liner manufacturer. If you
have further questions, consult with your independent, authorized dealer and/or visit the
manufacturer’s website at www.dicor.com .
CLEARANCE LIGHTS
Inspect all exterior lights to make sure they do not have moisture trapped inside. The
“weep” holes at the bottom of the lights must be kept open to allow moisture to escape from
the light fixture.
DOORS, EXTRUSIONS, WINDOWS & VENTS
These components have putty tape between the component and the wall surface. Portions
of these items may have a cap seal added as a secondary seal. Inspect these seals at least
once per year. Both putty tape and cap seals can become damaged by U.V. exposure, air
pollution, freezing temperatures and exposure to the elements. Therefore, they need to be
resealed from time to time.
Locks on entrance and baggage doors need biannual lubrication.
Silicone lubricant is recommended. Conditions such as rain, salt,
dust and pollution may increase the maintenance needs.
Inspect and seal the door frame threshold corners one time each
year. Refer to Fig. 30which indicates the referenced location.
Entrance Door
The entrance door installed in your vehicle is the result of years of design and testing to
provide you, the homeowner, with the most carefree and functional product available.
To keep your door operating in the manner, in which it was designed and delivered to you,
there is some routine maintenance items that should be handled on a regular basis.
• Strike Plate Adjustment - The door in your motorhome was installed and adjusted
in a factory setting and the setting of the striker plate may change over the course of
time and road conditions. Therefore, the setting may need to be changed or adjusted
to insure that your door operates as smoothly and efficiently as it should. To adjust
the strike plate, loosen the two screws holding the strike plate to the jamb system.
Move the plate in or out as needed to obtain a proper seal and closing force and
retighten the screws. To adjust the strike bolt in the rotary lock, loosen the bolt with a
5/8” socket or box end wrench, move the bolt in the direction needed and retighen the
bolt to 35 foot pounds of torque. The door in your motorhome operates much like an
84 Granite Ridge/Greyhawk/Escapade Type C Motorhome
Maintaining Your Investment...
Fig. 30