Jayco Granite Ridge Greyhawk Escapade 2005, Руководство пользователя

Страница: 67 / 112

UTILITIES & SYSTEMS
.
NOTE: Make sure you have read and understand all safety information found in
this manual and manufacturer supplied information.
PLUMBING SYSTEM
For set up instructions of your plumbing system, refer to the “Setting Up Camp...” chapter.
If you have further questions on setting up the system, consult with your independent,
authorized dealer.
Potable water systems require periodic maintenance to deliver a consistent flow of fresh
water. Depending on use and the environment the system is subject to, sanitizing is
recommended prior to storing and before using the water system after a period of storage.
Systems with new components, or ones that have been subjected to contamination, should
also be disinfected.
I
WARNING: Failure to sanitize the potable water system could result in
death or serious illness.
Follow the instructions supplied for your unique water system to determine the proper
procedure for sanitizing your unit. If you have further questions, consult with your
independent, authorized dealer.
Utility Center (Manifold) Sanitizing
The follow instructions are applicable to all units equipped with a “basement” or utility
center water system. Read, understand and follow all instructions as supplied here to
sanitize your system.
1. Drain the water tank, water lines and water heater completely by opening all
faucets and low point drains until the tank and heater are empty.
2. In a large bucket prepare a chlorine solution, using 3/4 cup of household bleach
and three (3) gallons (12 liters) of water.
3. Attach the intake hose to the city fill connection located inside or under the utility
center panel. (Fig. 13) Place the free end of the intake hose in the bucket of
chlorine solution.
4. Position the valves on the utility panel to the “Sanitize Tank” configuration. (Fig.
12) The low point drains located directly below the utility center must be closed
for the chlorine solution to siphon through the lines.
5. Turn the demand pump switch (Fig. 13) to the “ON” position and pump all of the
chlorine solution into the tank.
6. After pumping all the chlorine solution into the tank, position the valves to the
“City Fill” configuration. (Fig. 12)
7. Attach a garden hose to the city fill connection (Fig. 13) and finish filling the tank.
8. Open the kitchen and bathroom faucets to allow air to escape the water lines and
the water heater.
9. Turn the demand pump switch to the “ON” position and allow several seconds for
the pump to prime. (Fig. 13)
Granite Ridge/Greyhawk/Escapade Type C Motorhome 57