Jayco Eagle TT 2020, Руководство пользователя

Страница: 55 / 201

Section 4: Vehicle Operation
53
MANUAL LEVELING JACK:
1. Press MANUAL MODE. (U below) Use bubble level on the display to guide you.
When the bubble is in the center of the circle the unit is level.
2. Press and hold FRONT, REAR, LEFT or RIGHT and the jacks move as follows:
•
FRONT: Tongue jack on the front of the unit.
•
REAR: Both leveling jacks on the rear of the unit (closest to axles).
•
LEFT: The left rear leveling jack (road side).
•
RIGHT: The right rear leveling jack (curb side).
1. Press RETRACT (V below) and then press and hold FRONT, REAR, LEFT or RIGHT.
The jacks will move in the same grouping as listed above.
2. Press ON/OFF to deactivate the display.
3. Close and latch the cover over the touch screen display.
MANUAL OVERRIDE PROCEDURE:
Tongue Jack Manual Override
The electric tongue jack can be overridden and operated manually in the event of a malfunc-
tion. There are two methods to manually operate the tongue jack.
Method 1
At the bottom of the tongue jack motor there is a round plastic plug. Remove the plastic
plug to expose a 5/16” override hex adapter. Use a drill with a 5/16” socket and rotate hex
adapter to operate the tongue jack.
NOTE: Run the rear leveling jacks all the way to the ground before
lifting side to side.
Fully retract stabilizers before retracting / extending leveling legs. Press and
hold EXTEND/RETRACT to move stabilizers or select another mode.
