Jayco EAGLE FW 2020, Руководство пользователя

Страница: 74 / 201

Section 5: Slideout Systems
72
10. Install the transit bars (if so equipped) to
the slideout room and take the unit to an
authorized dealer for service.
Refer to the Power Gear® Electric Slideout
Operation Manual for detailed operation,
safety and troubleshooting information.
Power Gear Slim Rack Slideout System
The Power Gear® Slim Rack slideout is typi-
cally used for slideouts 144” long and longer.

It is operated by a 12VDC electric
motor.

The system is equipped with a
manual override allowing the room
to be extended / retracted in the
event of a power loss.

The system has a controller (Fig 1) with program-
mable stops that stop the motor when the room is
fully extended or retracted.

The controller has the ability to detect faults for
easier troubleshooting.

A wall mounted touchpad allows room movement
and provides end user feedback.
Operating the Slideout
The slideout will not function until the stops are properly set
or faults are cleared.
A solid “ON” GREEN LED
indicates room movement.
The RED LED indicates a fault or a problem
with the sys-
tem. (Refer to the
Fault Diagnostics / Troubleshooting
).
Prior to moving the slideout room set the parking brake.
To ensure ample voltage is being supplied to the slideout sys-
tem motor, power should be supplied from one of the follow-
ing sources:
 Attach the RV to shore power. Have the mo
-
torhome engine running.

Turn on the generator.
Extending/retracting the room:
1. Engine or generator must be running, or plugged into
shore power.
2. Transmission must be in park or neutral (if applicable).
3. Set the parking brake and level the unit.
4. Remove transit bars (if so equipped) if extending the
room; install if retracting.
5. Turn
ON the on/off switch or key.
6. Press and hold the OUT button (Fig 4). To retract, press
and hold the IN button. There will be a slight delay be-
fore the room begins moving.
7. The GREEN LED should be solid ON when room is in
motion.
Fig.1 Slideout Controller