Jayco ALANTE 2023, Руководство пользователя

Страница: 97 / 139

91
Section 8: Plumbing System
12. Attach a blowout plug to the City Water Inlet
on the utility center panel (
Fig 2
).
13. Attach the air hose to the blowout plug. Set
the compressor to
30 PSI
. Set the four-col-
or valves to 45° angle (
Fig 2). Red, Blue,
Green & White valves must be set at 45°
before applying air pressure 30 PSI Max.
14. Blow air into the utility center (
30 PSI Max
).
Water lines should be clear in 5 to 10 min-
utes.
15.
Turn off air supply; remove air hose and blowout plug.
16. Close low point drains; replace the water heater drain plug. Tankless water heater
should now be purged of water.
17. Set the colored valves to the WINTERIZE positions.
18. Pour one cup of RV antifreeze in all drain P-traps (sinks and bathtub).
Winterize the Black Tank Flush
1. Connect the blowout plug to the Black Tank Flush inlet at the utility center panel.
2.
Colored valves have no effect on the black tank flush inlet.
3. Connect the air hose to the blowout plug. Set the compressor to
30 PSI maximum
.
4. Make sure the black tank has been emptied. Open the black tank drain gate valve.
5.
Blow air into the flush inlet for 30 to 60 seconds.
6. Disconnect the air hose, compressor and blowout plug.
7. Close the black tank drain gate valve (typically under the RV).
Water Heater
Your RV is equipped with a tank (storage) water heater.

Hydrogen gas may result if you have not used the water heater for two
weeks or more.
HYDROGEN GAS IS EXTREMELY FLAMMA-
BLE
. To reduce the risk of injury under these conditions, open the hot
water faucet for several minutes at the kitchen sink before you use any
electrical appliance connected to the hot water system. If hydrogen is
present, you may hear what sounds like air escaping through the pipe as
the water begins to flow. Hydrogen gas may be present even after water
has been drained from the water heater tank. Open the faucet at the sink
and allow the system to vent for five to ten minutes. Do not smoke or
have any open flame near the open faucet while venting. On DSI water
heater models, make sure the switch is OFF.

Do not alter the operation or change the design/construction of your wa-
ter heater. For your safety, only factory authorized parts should be used
on your water heater. Accessories marketed for recreation vehicles, such
as an “add-on” electric heating elements, are not recommended by the
manufacturer. Such items are not approved to be installed and could cre-
ate an unsafe condition and will void all warranties.
 If you smell propane gas then STOP!
and follow the procedures listed
in the
Propane System
section before attempting to operate the water
heater.
Table of Contents Maintenance Record