Jayco ALANTE 2023, Руководство пользователя

Страница: 60 / 139

54
Section 6: Electrical System
Energy Management System 30A
Key features of the Power Control System include:

Limits total current to 30 Amps.

Minimizes circuit breaker tripping.

Monitors current draw for the entire RV including loads added by the owner.

Learns controlled appliance current draw.

Allows (2) air conditioners to run on 30 Amp service when other appliances are
not in use. Panel has built in relays to control (2) air conditioners.
Operation
This system monitors incoming power and has the ability to turn off a few select loads. It can
manage incoming power and avoid tripping the shore circuit breaker.
30A Service would be the normal setting displayed on the digital readout. By pressing the
SELECT button you can toggle from 30A to 20A to 15A. When the RV is plugged into a
15 Amp or 20 Amp power supply (i.e. at your home), you would change the display to the
20A or 15A Service setting. The system then attempts to keep the total coach 120VAC cur-
rent draw under that threshold to prevent tripping your home circuit breaker. It does this by
removing power for certain appliances. The status window will illuminate each of the appli-
ances it controls. By using the scroll button you can view the appliances the system controls:

Water Heater

Refrigerator

Rear AC

Front AC
The device name will display with either SHED or POWERED next to it depending on total
amperage available to the coach and whether or not the device is capable of being operated
under the existing load. If a device is showing SHED, it has been disabled and cannot be
used.

Awning control switches (press and hold to extend /
retract)

Systems monitor with LED indicators for tank levels and
battery charge status

Auto leveling control panel (for leveling the RV)

Inverter panel (power switch with display)

Power bunk bed lift control switch

Speaker selector switch
Touch Dimmer Switch
Some models may include a touch dimmer switch next to the Com-
mand Center panel.

Turn the ceiling lights ON or OFF: Tap the LED light on
the dimmer.
 Dimmer: If lights are off, press on the LED light and
lights will begin turning on gradually until fully lit. If
lights are on, press on the LED light and lights gradually
begin to turn off.
The dimmer has a memory and remembers what light setting last
used. When turned ON again, the lights return to that setting.
™
NOTE: If your RV model includes the 5 way/8 way remote control, the
LIGHT button on the remote only controls the awning LED lights.
Command Center Panel
w/Switch Modules
Table of Contents Maintenance Record