Jayco Alante 2018, Руководство пользователя

Страница: 70 / 169

60
Section 5: Slideout Systems
Operating the switch after the room is fully extended or retracted may damage the switch
and motor.
After the slideout is extended, visually inspect the slideout and the
surrounding area to make sure the slideout has extended properly
and has adequate clearance from any outside obstructions.
If the slideout is equipped with rubber seals, verify that the corners
of the black rubber seal are set up correctly. The seal corners are
cut at a 45° angle. The top of the outside seal must overlap the side
of the seal to avoid the possibility of water penetration. On the
inside seal, the side seal should overlap the top.
General Slideout Troubleshooting Checklist
If the slideout does not move when the slideout switch is depressed, follow these steps:
Check the auxiliary battery (customer supplied) for a full charge and good wire
connections.
Check the 12-volt fuse or circuit breaker.
Check for loose connections at the slideout motor.
If the slideout still will not operate, follow these steps:
If the slideout is extended, refer to the section on operating the specific slideout system
installed on your RV.
If the slideout is retracted, leave it in that position.
If the slideout extends crooked or only one side moves:
Follow steps on overriding the specific slideout system installed on your RV.
You may need to push the side that is not sliding to get it to retract all the way.
Contact your dealer or customer service for repair assistance.
Slideout Systems
Your RV may be equipped with one or more of the following slideout systems.
Flush Floor Slideout
For optimum performance, the slideout system requires full battery current and voltage.
Although the system is almost maintenance free, actuate the room once or twice a month to
keep the seals and internal moving parts lubricated.
Trouble shooting the flush floor slideout
Refer to the general troubleshooting check list before proceeding.
Slideout overlap-outside
NOTE: For long-term storage it is recommend the room be closed
(retracted).
NOTE: For additional troubleshooting information, refer to the
specific slideout system detail.
Table of Contents Maintenance Record