Jayco 2016 PINNACLE, Руководство пользователя

Страница: 69 / 167

59
S
lideout
S
yStemS
4. Retracting slideout room
Press the IN section of the slideout control switch and hold it until the motor stops.
Operating the switch after the room is fully retracted will damage the switch and
motor.
Maintenance
Your slideout system has been designed to require very little maintenance. To ensure a long
life of your slideout system, read, understand and follow these simple instructions. This
system contains a pre-lubed bearing that is lubricated when the room is moved in and out.
Do not spray oil or grease on the rails while the room is extended.
Do not work on your system unless the 12-volt DC (auxiliary battery, customer
supplied) and 120-volt AC electrical systems (shore line power cord) have
been disconnected.

T roubleshooting The Slideout
If the slideout does not move when the slideout switch is depressed, follow these steps.
Check the auxiliary battery (customer supplied) for a full charge and good wire
connections.
Check the 12-volt fuse or circuit breaker.
Check for loose connections at the slideout motor.
If the slideout still will not operate, follow these steps.
If the slideout is extended, refer to the following section on overriding the specific
slideout system installed on your RV.
If the slideout is retracted, leave it in that position.
Contact your dealer or customer service for repair assistance.
M
ANUAL OPERATION
Schwintek Inwall slideout system
The Schwintek system comes with an “electronic” manual override. In event the slide out
does not extend or retract follow these steps to override the system which should allow the
slideout to be retracted.
Manual override
1. Locate the slideout system controllers. There should be one for each slideout on the
recreation vehicle. They are typically located in the basement compartment in the
forward section of the recreation vehicle, either on the forward wall or on the ceiling.
In some models they may be behind a cargo lined panel.
NOTE:
Fuses for the slideouts can be found in the load center and
may be designated as auxiliary or slideout motor.