Jayco 2016 PINNACLE, Руководство пользователя

Страница: 56 / 167

46
v
ehicle
o
peration
N avigation System (If So Equipped)
Refer to the manufacturer’s user guide for detailed operating instructions.
C ampsite Hook-Up
Refer to Electrical System section before connecting the shore line power cord (when
using full hook-up) OR before starting the generator (if so equipped) or operating the
vehicle on 12-volt power when dry camping.
Refer to Fuel & LP System section before using the LP system. Open the LP gas tank
valve (if so equipped) slowly. There may be air in the lines and five to thirty seconds
of time is needed to bleed air before LP vapor fills the lines
.
Refer to Plumbing Systems section before connecting the fresh water supply or turning
ON the water pump or water heater.
When using full hook-up, connect the sewer hose to the campsite sewer hook-up.
If applicable, start the refrigerator and the cooling or heating system.
L
eveling the RV
Now that you have parked your RV, you need to ensure it is level. Leveling is very important.
A level RV is more comfortable for sleeping and walking.
NOTE:
For extended dry camping, management of all your re -
sources is essential. Check your battery levels and conserve battery
power, use it sparingly.
R
ear Backup Camera Prep
Your recreation vehicle has been pre-wired to allow installation of a (customer supplied &
customer installed) rear backup camera. Wiring is in place to install the camera at the rear
of the vehicle, and has been routed to the master bedroom to allow a hookup for the camera
monitor.