Wireless Contact Sensor
38mm
66mm
15mm
38mm
SET
1
4
2
3
5
Installation Guide
Overview
Name: Wireless Contact Sensor
Battery Type: CR2032 x 1
Dimension: 34 x 65 x 13 mm (w/o bracket)
34 x 65 x 15 mm (w/ bracket)
Magnet: 12 x 39 x 10 mm
Names of Parts
1. Status LED
2. Reed Switch Indicator
3. Battery Holder
Features
Burglar-Proof – once the device is triggered, the device will automatically send the signal wirelessly to the Gateway for
monitoring the door/window status.
Power Saving – one coin cell battery can be used for more than 1 year. It is also equipped with the low battery alert function.
Easy Setup – simply press the
SET
button on the device to join the system.
RSSI Functionality – the signal strength is indicated by its LED indicator and behavior.
Tamper-Proof Functionality – the function will be enabled when the device joins to the system. If the device is moved, it will
automatically send a signal to the Gateway.
4. SET Button
5. Bracket
Installation
Device Installation and Binding
1. Install the battery into the battery holder.
Attention:
Make sure the positive (+) pole is facing up.
Status
LED Color and Behavior
Good
Normal
Poor
No Signal
Blinks green (very quickly) for 15 seconds.
Blinks green (quickly) for 15 seconds.
Blinks green (slowly) for 15 seconds. (not recommended)
Blinks red for 3 seconds and then turns off. (not recommended)
CAUTION
RISK OF EXPLOSION IF BATTERY IS
REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES
ACCORDING TO THE INSTRUCTIONS.
2. Short press the
SET
button at the back of the
Gateway or Router (Power Switching). Then
short press the
SET
button on the device.
The Gateway/Router and the device are
joining as both LED indicators blink (around
15 seconds). Wait for few seconds until both
LED indicators are turned off, indicating the
device binding process is successful.
Open the battery holder.
Insert battery.
Close the battery holder.
Mount the bracket.
Install it onto the bracket.
Note:
If the device binding process is failed, both LED indicators on those joined devices will light red once after blinking.
3. Mount the bracket and magnet on the door/window.
Device Deletion
To remove the device binding, press the
SET
button for 5 seconds. The LED
indicator blinks green and then turns off. After few seconds, the LED indicator
blinks red and then turns off again, indicating the deletion process is complete.
Checking Device Received Signal Strength Indication (RSSI)
Short press the
SET
button on the device twice.
The signal strength is indicated by its LED indicator.
