JAWA B, Спецификация и руководство оператора

Страница: 46 / 65

46
of the splines driver remove the bearing circlip. From the opposite side push the
other bearing using a piece of tube until the unlocked bearings fall out. Push the
remaining bearing out to the opposite side and remove the spacer. Warning!
Before removing the front wheel bearings the hub cover (of the splined driver)
should be removed first. Press in the new bearings by applying pressure to the
outer bearing race, using a piece of tube. When replacing the rear chainwheel
bearings proceed as follows : Remove the back plate and push out the spacer.
Remove the seal, bearing circlip and bearing from the L. H. side using a piece of
tube. Press on the new bearing using again preferably a piece of tube of a diameter
corresponding to the bearing outer race diameter.