Javad UHFSSRx, Руководство пользователя

Страница: 20 / 23

20 www.javad.com
KNW [Parameters List]
Parameter
List
Short description
XXX
XXX - the certified data source (three hex sym-
bols).
The KNW command without parameter prints KNW
code.
Special Commands
BOOT
The BOOT command is intended to reboot the unit.
HELP
The HELP command types the list of popular com-
mands:
Popular Commands
BOOT - Reboot the unit
INFO - Product ID along with Hardware/
Software Versions
STATE - Transceiver Status
SAVE - Save Current Configuration into
Configuration File
+++ - (without <CR>) - Exit Data Mode
DATAMODE - Exit Command Mode
LINK - Print RF Link Operation Mode
XMOD IMAGE - Activate X-Modem Protocol
to load Firmware
TSTSGL /? - Displays Test Signals par-
ticularity
See Manual for details
@00
SAVE
The SAVE command is intended to store the unit’s
currently used configuration into the Configuration
file. The configuration stored in the Configuration file
is activated automatically after unit’s reboot.
CFG2DFLT
The CFG2DFLT command cleans current Configura-
tion. After BOOT command all configuration parame-
ters will be default.
XMOD IMAGE
The XMOD IMAGE command in Maintains Mode ac-
tivates X-modem protocol to download the Modem
part of the Firmware Image.
Use this command with one delimiter: “XMOD IM-
AGE<CR>“ or Command “XMOD IMAGE<LF>“.
Note:
Command “XMOD IMAGE<CR><LF>“ will be accepted
as command “XMOD IMAGE<CR>” and byte of Firmware Image
0x0A.
Identification and Diagnostics
Commands
INFO
The INFO command is used to retrieve the SS Radio ID
along with its Hardware version, the loaded real- time
software version/revision and BootLoader’s version.
INFO [Parameter Name] [/?]
Parameter
Name
Parameter List
ID Product ID
SN Serial Number (SN)
HW 3 – hardware revision
FW 2.2.30 - firmware version
BL 4.03 - BootLoader Version
The INFO command without Parameter Name indi-
cates all values:
FH915 Land Mobile Radio, Javad GNSS.
Product ID =41
S/N =30196
Hardware =3
Firmware =2.2.32
BootLoader =4.03
STATE
The STATE command is used to check the state of the
wireless link.
STATE [Parameter Name][/?]
Parameter
Name
Parameter List
Region 0-EU; 1-USA; 2-Australia
Tx Displays the initial frequency of the transmitter