Javad TRIUMPH-VS, Руководство оператора

Страница: 28 / 96

Description and Operation
Base and Rover Setup
Base Station Configuration
28 www.javad.com
4. Base and Rover Setup
Both Base and Rover receivers must be configured according to the desired survey method.
• In applications where real-time positioning results are required, the Base receiver provides the
correction information needed to properly calculate the location of the Rover receiver. A Base
station is normally set up over a known point and collects GPS/GLONASS data from satellites.
As the receiver picks up satellite data, it measures the carrier and code phases to accurately
compute and verify its location. Then, the receiver transmits this information via radio (UHF or
GSM) to the Rover receiver.
• The Rover receiver applies correction information from the Base station to its current location to
accurately calculate one or more points. Rovers are mobile GNSS receivers on a survey pole or
bipod that compares the information from the Base station to the data it logs from satellites and
applies correction algorithms to accurately calculate a new point.
• In applications intended for post-processing, the receivers typically log code phase and/or carrier
phase measurements separately from common satellites and during the same time interval. This
data is then processed using post-processing software (for example, Justin).
4.1. Base Station Configuration
Base via UHF modem
Note:
To return to Main screen, press the Home button on the front panel of TRIUMPH-VS.
Note:
Always tap Apply or press the Apply button , to save the settings and parameters into receiver’s
memory.
1. To set up the base station, tap Settings on the Main screen:
Figure 29. Settings