Javad HPT901BT, Руководство пользователя

Страница: 28 / 44

Command Line Interface
Special Commands
28 www.javad.com
The
DST
command without parameter prints DST code.
2.16. KNW
The KNW command defines the code of the certified data source
.
KNW [ Parameters List ]
The
KNW
command without parameter prints KNW code.
3. Special Commands
3.1. BOOT
The BOOT command is intended to reboot the unit.
3.2. HELP
The HELP command types the list of popular commands:
Popular Commands
BOOT - Reboot the unit
INFO - Product ID along with Hardware/Software Versions
STATE - Transceiver Status
SAVE - Save Current Configuration into Configuration File
+++ - (without <CR>) - Exit Data Mode
DATAMODE - Exit Command Mode
LINK - Print RF Link Operation Mode
XMOD IMAGE - Activate X-Modem Protocol to load Firmware
TSTSGL /? - Displays Test Signals particularity
See Manual for details
@00
XXX XXX - the data destination code ( three hex symbols ) .
Parameter List Short Description
XXX XXX - the certified data source ( three hex symbols ) .