Jatco RE4F04B, Руководство пользователя

Страница: 485 / 708

DTC P0710 A/T FLUID TEMPERATURE SENSOR CIRCUIT
AT-485
[RE5F22A]
D
E
F
G
H
I
J
K
L
M
A
B
AT
Revision: November 2006 2006 Altima
TCM terminals and data are reference value. Measured between each terminal and ground.
Diagnostic Procedure
ECS009E3
1.
CHECK FLUID TEMPERATURE SENSOR SIGNAL
With CONSULT-II
1. Start engine.
2. Select “A/T” with “DATA MONITOR” mode in CONSULT-II.
3. Read out the value of “FLUID TEMP SE”.
Without CONSULT-II
1. Start engine.
2. Check voltage between TCM connector terminals 41 and 42
while warming up A/T. Refer to
AT-484, "Wiring Diagram — AT
— FTS" .
3. Turn ignition switch “OFF”.
4. Disconnect the TCM connector.
5. Check if there is continuity between the connector terminal and ground.
OK or NG
OK >> GO TO 6.
NG >> GO TO 2.
Terminal
Wire
color
Item Condition
Data (Approx.)
41 R/Y
Fluid temperature
sensor
When ATF temperature 0
°
C (32
°
F) 4.0V 9.8 k
Ω
When ATF temperature 20
°
C (68
°
F) 3.0V 4.2 k
Ω
When ATF temperature 80
°
C (176
°
F) 0.8V .54 k
Ω
When ATF temperature 100
°
C (212
°
F) 0.5V .31 k
Ω
42 LG
Fluid temperature
sensor ground
Always 0V
Item name Condition Display value (Approx.)
Fluid temperature sensor
0
°
C (32
°
F) 4.0V
20
°
C (68
°
F) 3.0V
80
°
C (176
°
F) 0.8V
100
°
C (212
°
F) 0.5V
SCIA2870E
Connector Terminal Temperature Voltage (Approx.)
F57 41 - 42 (ground)
0
°
C (32
°
F) 4.0V
20
°
C (68
°
F) 3.0V
80
°
C (176
°
F) 0.8V
100
°
C (212
°
F) 0.5V
SCIA2871E