Jatco RE4F04B, Руководство пользователя

Страница: 322 / 708

AT-322
[RE4F04B]
REPAIR FOR COMPONENT PARTS
Revision: November 2006 2006 Altima
6. Remove reverse clutch piston from reverse clutch drum by turn-
ing it as shown.
7. Remove D-ring and oil seal from piston.
INSPECTION
Reverse Clutch Snap Ring, Spring Retainer and Return Springs
Check for deformation, fatigue or damage. If damaged, replace.
Reverse Clutch Drive Plates
●
Check facing for burns, cracks or damage.
●
Measure thickness of facing.
●
If not within wear limit, replace.
Reverse Clutch Dish Plates
●
Check for deformation or damage.
●
Measure thickness of dish plate.
●
If deformed or fatigued, replace.
Reverse Clutch Piston
●
Make sure that check balls are not stuck.
●
Apply compressed air to check ball oil hole opposite the return spring. Make sure there is no air leakage.
●
Apply compressed air to oil hole on return spring side to make sure that air leaks past ball.
ASSEMBLY
1. Install new D-ring and new seal ring on piston.
CAUTION:
●
Do not reuse D-ring and seal ring.
●
Apply ATF to new D-ring and new seal ring.
●
Take care with the direction of new D-ring and new seal
ring.
SCIA3319E
Thickness of drive plate:
Standard value : 1.6 mm (0.063 in)
Wear limit : 1.4 mm (0.055 in)
SAT162D
Thickness of dish plate : 3.08 mm (0.1213 in)
SAT163D
SCIA4887E