Jaspi Inverter Nordic 8, Руководство по установке

Страница: 30 / 68

General
JÄSPI Inverter Nordic is equipped with an internal elec-
tronic controller that handles all functions necessary for
operation of the heat pump, e. g. defrosting, stop at
max/min temperature, connection of the compressor
heater, and protective functions during operation.
The integrated control shows information via status-LEDs
and can be used during servicing.
Under normal operating conditions the home owner
does not need to have access to the controller.
JÄSPI Inverter Nordic communicates with the Kaukora
indoor module/control module, which means that all
settings and measurement values from JÄSPI Inverter Nor-
dic are adjusted and read off on the indoor module/con-
trol module.
LED status
The base board (AA2) has a status LED for easy control
and troubleshooting.
Explanation State LED
Base board without power Not lit PWR
(green)
Base board power on Continuous
light
CPU without power Not lit CPU
CPU running Flashes (green)
CPU not running correctly Continuous
light
No communication with in-
door module/control mod-
ule Not lit EXT COM
(green)
Communication with indoor
module/control module Flashes
No communication with in-
verter Not lit INT COM
(green)
Communication with invert-
er Flashes
Neither defrosting nor pro-
tection is active Not lit DEFROST
(green)
Some protection is active Flashes
Defrosting in progress Continuous
light
No errors Not lit ERROR
(red)
Info alarm (temporary), act-
ive Flashes
Continuous alarm, active Continuous
light
Relay in de-energised posi-
tion Not lit K1, K2, K3,
K4, K5
Relay activated Continuous
light
No function N-RELAY
No function COMPR. ON
Explanation State LED
Inverter without power Not lit PWR-INV
(green)
Inverter has power Continuous
light
Harmonic filter (RA1)
Harmonic filter (RA1) has a status LED for easy control
and troubleshooting.
When the capacitor is in operation, LED 201 is lit with a
steady light.
Explanation State LED
Capacitor disconnected Not lit LED 201
(red)
Capacitor connected Continuous
light
Master control
To control JÄSPI Inverter Nordic, a Kaukora indoor
module/control module is required, which calls upon
JÄSPI Inverter Nordic according to demand. All settings
for JÄSPI Inverter Nordic are made via the indoor mod-
ule/control module. It also shows the status and sensor
values from JÄSPI Inverter Nordic.
Paramet-
er space Value Description
4 – 14 4 °C Cut-out value activation
passive defrosting
-5 – 5 -3 °C Start temperature BT16 to
calculate index
Yes / No No (1 / 0) Permit fan de-icing
Yes / No No (1 / 0) Permit silent mode
Yes / No No (1 / 0) Permit defrost more often
JÄSPI Inverter Nordic Chapter 7 | Control 30
7 Control