Jaspi Inverter Nordic-12, Руководство по установке, Страница: 9 / 68

Transport and storage
JÄSPI Inverter Nordic must be transported and stored
vertically.
NOTE
Ensure that the heat pump cannot fall over
during transport.
Ensure that the heat pump cannot be damaged during
transportation.
Assembly
■
Place JÄSPI Inverter Nordic outdoors on a solid level
base that can take the weight, preferably a concrete
foundation. If concrete slabs are used they must rest
on asphalt or shingle.
■
The lower edge of the evaporator must be at the level
of the average local snow depth. The concrete found-
ation or concrete plinths must therefore be at least 70
mm high.
■
JÄSPI Inverter Nordic should not be positioned next
to noise sensitive walls, for example, next to a bed-
room.
■
Also ensure that the placement does not inconveni-
ence the neighbours.
■
JÄSPI Inverter Nordic must not be placed so that recir-
culation of the outdoor air can occur. This causes lower
output and impaired efficiency.
■
The evaporator must be sheltered from direct wind / ,
which negatively affects the defrosting function. Place
JÄSPI Inverter Nordic protected from wind / against
the evaporator.
■
Some water may drip from the drainage hole below
JÄSPI Inverter Nordic. Make sure that water can run
off by selecting a suitable material underneath
JÄSPI Inverter Nordic (see page 10).
■
Care must be exercised so that the heat pump is not
scratched during installation.
LEK
F2120
min 300 mm
LEK
F2120
LEK
min
70 mm
Do not place JÄSPI Inverter Nordic directly on the lawn
or other non solid surface.
If there is a risk of snow slip from roof, a protective roof
or cover must be erected to protect the heat pump, pipes
and wiring.
9 Chapter 2 | Delivery and handling JÄSPI Inverter Nordic
2 Delivery and handling