A WILKINSON STAR PRODUCT 09-18 ISSUE 1
OPERATION
Before starting any welding activity ensure that
you have suitable eye protection and protective
clothing. Also take the necessary steps to protect
any persons within the area.
MACHINE DISPOSAL
Please do not dispose of electrical waste with
normal waste products.
In accordance with the European directive 2002/96/
EC regarding waste electrical and electronic
equipment and its implementation into national law
any electrical or electronic which has reached its
end of life must be collected separately and
disposed of via a suitable recycling facility.
The owner of the equipment is required to return
the equipment to a suitable recycling facility or to
Wilkinson Star Limited for the correct recycling of
the product.
7 MAINTENANCE AND
TROUBLESHOOTING
The following operation requires sufficient
professional knowledge on electric aspects and
comprehensive safety knowledge. Make sure the
input cable of the machine is disconnected from
the electricity supply and wait for 5 minutes before
removing the machine covers.
In order to guarantee that the arc welding machine
works efficiently and in safety, it must be
maintained regularly. Operators should understand
the maintenance methods and means of arc welding
machine operation. This guide should enable
customers to carry on simple examination and
safeguarding by oneself, try to reduce the fault rate
and repair times of the arc welding machine, so as
to lengthen service life of arc welding machine.
Troubleshooting
Before arc welding machines are dispatched from
the factory, they have already been checked
thoroughly. The machine should not be tampered
with or altered. Maintenance must be carried out
carefully. If any wire becomes loose or is misplaced,
it maybe potential danger to the user!
Only professional maintenance personnel should
repair the machine!
Ensure the power is disconnected before working
on the machine. Always wait 5 minutes after power
switch off before opening the case.
Period
Maintenance Item
Daily
Examination
Check the condition of the machine,
mains cables, welding cables and
connections.
Check for any warnings LEDs and
machine operation.
Monthly
Examination
Disconnect from the mains supply
and wait for at least 5 minutes
before removing the cover. Check
internal connections and tighten if
required. Clean the inside of the
machine with a soft brush and
vacuum cleaner. Take care not to
remove any cables or cause damage
to components. Ensure that
ventilation grills are clear. Carefully
replace the covers and test the unit.
This work should be carried out by
a suitably qualified competent
person.
Yearly
Examination
Carry out an annual service to
include safety check in accordance
with the manufacturers standard
(EN 60974-1).
This work should be carried out by
a suitably qualified competent
person.
