QMP16SU Service Manual
| 43
9. Remove the clamp.
10. While holding the basket in the down position
and from turning, rotate the hand wheel until
the second hook screw is accessible. Carefully
snug, then tighten the second screw. If you push
on the tool while tightening, the hook may move,
throwing the settings off.
11. Tighten both screws tight with the 2 mm handle
hex tool.
12. Reset the loop lift clamp and gauge again to
check that loop lift and needle distance are still
correct.
Hook screws without front cover
Â
IMPORTANT
: If loop lift, needle distance and needle height are not adjusted accurately, the machine
may skip stitches, shred thread or not sew.
Содержание QMP16SU
Страница 69: ...QMP16SU Service Manual 69 Notes...
