5
MS5027PR
THREADING OF MACHINE
THE NUMBERED STEPS BELOW FOLLOW THE NUMBERS ON THE ILLUSTRATIONS.
DOTTED LINES SHOW THE PLACES WHERE THE THREAD LOOPS AND IS THEN PULLED TIGHT.
RAISE THE TAKE-UP LEVER TO ITS HIGHEST POSITION BY TURNING THE HANDWHEEL TOWARD
YOU.
RAISE THE PRESSER FOOT LEVER.
PLACE THE SPOOL ON A PIN WITH THE THREAD COMING FROM THE BACK OF THE SPOOL.
1.
DRAW THE THREAD THROUGH THE THREAD GUIDE.
2.
HOLDING THE THREAD TAUT WITH YOUR RIGHT HAND, DRAW THE THREAD DOWN INTO THE
TENSION AREA AND THEN AROUND THE CHECK SPRING HOLDER.
3.
FIRMLY DRAW THE THREAD UP AND THROUGH THE TAKE-UP LEVER FROM RIGHT TO LEFT.
4.
PULL THE THREAD TO THE LEFT, AND SLIP IT INTO THE NEEDLE BAR THREAD GUIDE.
5.
THREAD THE NEEDLE FROM FRONT TO BACK.
NOTE: YOU MAY WANT TO CUT THE END OF THE THREAD WITH SHARP SCISSORS FOR EASIER
NEEDLE THREADING.
1
2
3
4
5
