Janome DE 5024, Руководство по обслуживанию

Страница: 16 / 29

MECHANICAL ADJUSTMENT
ZIGZAG STOPPER
If the needle tip hits with the needle plate (D) when the needle swings to the right at the
maximum zigzag width, adjust as follows.
(when the needle drop position in the needle plate hole deviates toward the right of the hole,
refer to “DISTRIBUTION OF NEEDLE SWING”.)
1. Set the stitch selector, zigzag width at ”6.5”.
2. Remove the top cover (See page 4).
3. Turn the hand wheel until the needle tip is located above the top surface of the needle
plate in descending travel at the right needle position.
4. Slightly loosen screw (A), lightly press the stopper (B) against the zigzag width crank (C),
and then temporarily tighten the set screw.
5. Push the zigzag width crank (C) in the direction of the arrow and turn the hand wheel to
make sure that the needle tip comes into contact with the needle plate (E). Tighten
screw (A) firmly.
6. Run the sewing machine and make sure that there is no hitting noise between the zigzag
width crank and the zigzag stopper. Attach the top cover.
14