UMG 96-PA / UMG 96-PA-MID / UMG 96-PA-MID+
www.janitza.de
44
NOTE
For the
UMG 96-PA-MID/MID+, other require-
ments apply for the password configuration
„14.9 Password configuration“ on page
To change the password, you need the current
password.
NOTE
·The measurement device locks the device con-
figuration for 15 minutes after the password has
been entered incorrectly four times.
·Write down your password and keep it safe!
·Without the password you cannot configure
your device! Notify the device manufacturer’s
Support if the password is lost!
Setting the password
·Open the
Configuration
window as previously
described.
·Use buttons 3 (
) and 4 (
) to select the item
System
and confirm with button 6 (
Enter
).
·The
System
window appears.
12.6.4 Reset
This function is used to delete and reset mea-
sured values and device parameters.
Energy
You can delete all energy meters in the device
simultaneously. It is not possible to select certain
energy meters.
NOTE
When resetting the
UMG 96-PA-MID/MID+
, the
certified energy values for active energy, delivered
and applied
cannot
be deleted!
·Open the
Configuration
window as previously
described.
·Use buttons 3 (
) and 4 (
) to select the item
System
and confirm with button 6 (
Enter
).
·The
System
window appears.
·Use buttons 3 (
) and 4 (
) to select the item
Reset
and confirm with button 6 (
Enter
).
·The
Reset
window appears.
·Use buttons 3 (
) and 4 (
) to select the item
Energy
and confirm with button 6 (
Enter
).
Fig.
Reset window, resetting the energy meters
·The entry for the
Energy
is shown "yellow".
·Use buttons 3 (
) and 4 (
) to select “
Yes
” or
“
No
”.
·Confirm your entries with button 6 (
Enter
) or end
the action by pressing button 1 (
Esc
).
·To return to the measuring display
Home
, press
button 1 three times (
Esc
) and then press button
2 (
Home
).
·Use buttons 3 (
) and 4 (
) to select the item
Password
and confirm with button 6 (
Enter
).
·The entry for the
Password
is shown "yellow".
·Use buttons 2 (
) and 5 (
) to change the
position of the digit to be set for each item and
use buttons 3 (
) and 4 (
) to change the digit
(-1/+1).
·Confirm your entries with button 6 (
Enter
) or end
the action by pressing button 1 (
Esc
).
·To return to the measuring display
Home
, press
button 1 twice (
Esc
) and then press button 2
(
Home
).
Fig.
System window with the item Password activat-
ed
NOTE
In addition to changes to current and voltage
transformer ratios, the
UMG 96-PA-MID/MID+
also saves each
Password change
in the integrat-
ed logbook.
The device locks the configuration of
passwords after 48 entries in the logbook.
