UMG 96-PA / UMG 96-PA-MID / UMG 96-PA-MID+
www.janitza.de
38
12. Configuration
12.1 The Configuration window
The
Configuration
menu of the device contains
all parameters in which you make settings. The
device requires the supply voltage for configura-
tion. To do so, proceed as described in 13.1 on
page 50:
NOTE
The configuration of the UMG 96-PA-MID/MID+ is
protected with a password (see „14.9 Password
·If you are
not
in the measuring display
Home
,
you can go to this view by pressing button 2
(
Home
).
·Open the menu with button 1 (
Menu
).
·Use buttons 3 (
) and 4 (
) to select the menu
item “
Configuration
” and confirm with button 6
(
Enter
).
·The
Configuration
window appears.
·Use buttons 3 (
) and 4 (
) to select the
language (
German
or
English
) and confirm with
button 6 (
Enter
).
·The user interface entries change to the selected
language.
·Use button 1 (
Esc
) to return to the menu.
·Then press button 2
Home
to go to the measur-
ing display
Home
.
Fig.
The Language Configuration window
Fig.
"Configuration" menu item
Fig.
Configuration window with activated language
item.
NOTE
Password-protected devices require entry of a
password before configuration! If your device
is password protected, enter your password to
access the Configuration window (see section
"12.8.3 Password" on page 34).
12.2 Language
Use the
Language
item of the
Configuration
window to configure the language for the device's
user interface:
·Open the
Configuration
window as previously
described.
·Use buttons 3 (
) and 4 (
) to select the item
Language
and and confirm with button 6 (
Enter
).
·The item
Language
is shown in yellow letters.
12.3 Communication
Use the
Communication
item of the
Configuration
window to configure parameters for the RS-485
interface of your device.
·Open the
Configuration
window as previously
described.
·Use buttons 3 (
) and 4 (
) to select the item
Communication
and and confirm with button 6
(
Enter
).
·The
Communication
window appears with the
parameters:
- Device address.
- Baud rate.
- Data frame.
