janitza 800-CT8-LP, Руководство пользователя и технические данные

Страница: 16 / 54

16
www.janitza.de 800-CT8-LP module
3.5 EU/UKCA Declaration of Conformity
Please see the EU/UKCA declarations of conformity
posted at www.janitza.de for the laws, standards and
directives applied by Janitza electronics GmbH for
the devices. The EU/UKCA conformity of the device
permits the marking CE/UKCA.
3.6 FCC Declaration of Conformity
The device:
·complies with Part 15 of the FCC Rules for Class
B digital devices (limits to protect against harmful
interference in a residential installation).
·generates, uses and can radiate high-frequency
energy
·can cause harmful interference to radio communi-
cations if not installed and used properly. There is
no guarantee that interference will not occur in a
particular installation.
If there is radio or television reception interference,
which can be determined by turning the device on
and off, proceed as follows:
·Align or reposition the receiving antenna.
·Increase the distance between the device and the
radio/television receiver.
·Connect the device and the radio/television receiver
in different circuits.
·if necessary, contact Janitza support or a radio/tele-
vision technician.
Code of Federal Regulations, Title 47, Part 15, Sub-
part B - Unintentional Radiators.
3.7 Transformers
It is not permitted to use the outputs of Janitza
measurement devices, components and modules for
switching protective devices or protective relays! Use
only "Current transformers for measuring purposes"
for Janitza measurement devices, components and
modules!
3.8 Scope of delivery
Quantity Part. no. Designation
1 52.31.234 800-CT8-LP module
(current measuring module)
1 52.31.206 Bus connector (1TE) -
current measuring module
1 33.03.892
Installation manual (DE/EN) "Cur-
rent measuring module for the
UMG 801"
1 33.03.342 "Safety information” supplement
(12 languages)
Tab. Scope of delivery, 800-CT8-LP current measuring module
INFORMATION
·The modules are delivered with the necessary
screw terminals and bus connectors (JanBus in-
terface) for connection to the basic device or other
modules.
·All supplied options and design variants are de-
scribed on the delivery note.
·The GridVis
®
network analysis software is available
at www.janitza.de and can be used to configure
your basic device with modules and read out data
for analysis (prerequisite: PC connection to your
basic device).
Quan-
tity
Part. no. Designation
1 10.01.953 End bracket
Tab. Scope of delivery, 800-CT8-LP current measuring module
3.9 Accessories