Low Cost Deer Deterrent
PART NO. 2168923
This kit contains a water-proof enclosure that will need to have four 1/4 inch holes drilled in it to accommodate the LED holders. The
PCB will need to be assembled and installed to the box with Velcro. A buzzer and battery pack will also be attached with Velcro. The
program for the PIC12F675 is pre-programmed and can be changed if desired.
Time Required: 30 minutes depending on experience
Experience Level: Intermediate
Required tools and parts:
Soldering Iron/Solder
#1 Philips Screw Driver
Optional: PIC programmer for PIC12F675
1/4 inch drill bit and drill
Bill of Materials:
Qty
Jameco SKU
Component Name
1
141841
Water Proof Enclosure
1
140695
Buzzer
1
1217519
FET
1
332672
Capacitor
1
216152
Battery Holder
1
223781
PIC Micro-controller
4
124927
LED Mount
1
615769
Silicone Sealant
4
2077061
SuperBrite LED White
4
2157175
Resistor 1/4W - 100 ohm
4
2157167
Resisitor 1/4W 10K Ohm
4
417501
LED Connector
1
112206
8-pin IC Socket
1
2125325
Velcro
1
35991
Diode
1
--
Printed Circuit Board
Step 1 - Assemble PCB
Completely install all the electronic components to the printed circuit board (PCB). Assemble the PCB as according to the schematic
making sure to use the LED connectors to attach the LEDs to the board. Pay special attention to the orientation of the LED polarity!
Solder the black wire to the pad closest to the flat part of the symbol on the board. Clip LED leads and insert into LED connectors.
Experiment with the length so that the LED fits snugly into the connector and the mount.
Make sure to solder the IC socket to the PCB, not the PIC chip itself. The PIC will be inserted into the socket after programming.
Make sure to match the diode stripe on the PCB with the diode component.
