JAI TM-6740GE, Руководство по эксплуатации

Страница: 29 / 80

Page 17
Configuring the TM-6740GE Camera
TM-6740GE Software
3.4.6 Look-Up Table
The look-up table control allows you to change two knee point values. You may enter X
1
, Y
1
, X
2
, Y
2
values directly to adjust the knee curve. The look-up table can be controlled interactively. The Table
Selection pull-down menu allows you to select the Linear or Gamma 45 option. This control also allows
you to check the positive or negative image option
FIGURE 17.
Look-Up Table
3.4.7 Memory Pages
All the camera parameters such as shutter mode, shutter speed, gain, offset level, scan mode, and LUT
can be saved into seven (7) available memory pages on the EEPROM in the camera. The pages are
numbered 0-6. The Load Page button loads the corresponding camera settings from the EEPROM while
the write page button writes the current camera settings to the corresponding memory page in the
EEPROM.
Page 1 is the power-up default page. Page 0 is the factory default. To save your current camera settings
for power up default, write the settings to memory page 1
FIGURE 18.
.Memory Pages
To reset memory page 1 to the factory default settings, load memory page 0 and save those settings to
memory page 1. Page 0 is password-protected and you cannot write to it. If you find that you do need to
write to page 0, contact JAI PULNiX for password access.
Note: configurations such as grabber settings, pulse generator, GPIO, and image setting must be saved
into the XML file. Please refer to Section 3.4.1, “Check the Current Camera Setting,” on page 13 for
more information.