User Manual (Ver.1.4) - Main Functions
GOX-5105MC-CXP | GOX-8105MC-CXP | GOX-12405MC-CXP | GOX-16205MC-CXP | GOX-20405MC-CXP | GOX-24505MC-CXP
- 109 -
CommandSequencer Mode
As with TriggerSequencer mode, you can define up to 32 indexes beforehand in this mode. Set
SequencerCommandIndex to point to one of your preconfigured indexes. This index will be executed
on each trigger, until it is changed to point to a different index, typically by your vision application.
In this way, Command Sequencer mode allows you to programmatically adjust your sequence in
response to image analysis or input from other sensors.
Notes:
l
The same index table will be executed for subsequent triggers unless the
CommandSequencerIndex value is changed.
l
SequencerFrameCount, SequencerSetNext and SequencerRepetition cannot be used in
CommandSequencer mode.
Non-Volatile Flash Memory
Storing Data in On-Camera Flash Memory
The camera has non-volatile memory for users to store data. Refer to the technical note “Storing Data
in On-Camera Flash Memory” for more information.
Note:
JAI strongly recommends saving images to the PC or other storage location because the
non-volatile flash memory may not have enough memory size to store large data.
