M-P2L1-1 EN
Page 26
Release Date: November 15, 2019
Rev 01
5.3.2.8 View addresses used in a loop
Press the Home key and then F1, press 8 to enter the menu View addresses used in a loop. Manually enter
the loop number from the numeric keypad, press either F2 or F3 to change the loop the user would like to
access.
All the addresses registered in the loop will be grouped by device type, followed by the quantity of devices
and the corresponding addresses in the loop-address format. The final information is the total number of
devices on the selected loop.
5.3.2.9 View address descriptions
Press the Home key, then F1 and then 8 to enter this menu to view descriptions of all registered addresses.
Users can manually enter the loop and address number to review the detailed descriptions. Pressing F2 or
F3 will move forward or backward in the list of addresses displayed, pressing F6 exists the menu.
5.3.2.10 View system composition and date of last configuration
Press
the Home key then the F1 and enter 0 on the keypad to enter the view system composition sub-menu.
The data of this menu displays in the format of:
X Loop Card X Loop
X Power card
Date of last configuration update: DD/MM/YYYY
Where X is the number of cards in the system.
