Jacuzzi lodge M, Использование и обслуживание

Страница: 20 / 60

20
Relax
Formed of the following colours: blue/orange/sky blue/white;
this sequence relieves stress and encourages relaxation; the or-
ange hue offers warmth in this sequence composed primarily of
“cold” colours.
Stable colours
You can also choose from the following colours, which appear in
stable fashion: white, light blue, orange, yellow, green.
Water filtering
Filtering, obtained through the combined action of a pump and a
cartridge filter, is indispensable to keep the water clean and trans-
parent, and to eliminate particles in suspension.
N.B.: some models are equipped with a UV light (Clearray ™), which
helps disinfect and purify the water. When the filtering cycle is start-
ed, the generator starts automatically, and shuts off at the end of
the cycle.
X
Clearray™ runs automatically and is contingent on the ac-
tivation of the pump (at low speed or the filtering pump, where
present) during the filtering cycle. It will be off if the hydromas-
sage or even one spotlight is on. This is because there is probably
a person in the tub. Forty (40) minutes after the functions are shut
off, Clearray™ begins operating again, provided a filtering cycle
is active.
Setting the filtering cycles
To set the filtering cycle:
X
Press the “ Ligh t” key and hold it down for about 5 sec-
onds. The display will show the message dx , where “x” indicates
the duration in hours.
X
Use the key “ Up/Down ” to enter the desired duration,
from a minimum of 0 to a maximum of 12 hours.
NOTE: hold the key down until you reach the desired value.
If the display is equipped with two separate keys, press the key
“ Up ” to increase the value or the key “ Down ” to decrease it.
X
Press the “ Light ” key once again to confirm the selected
value and to continue the programming of the start delay, com-
pared to time “0”, of the cycle
(parameter sy , where “y” indicates
the number of hours).
ATTENTION: the time “0” is the moment at which the hot tub is
powered on using the main switch, or the moment at which the
parameters are memorized. for example, you set as the cycle start
delay to “4”, it means that filtering will start 4 hours after you turn
on the hot tub, or after memorization of said parameters.
it is also possible to reduce the value of parameter “
s ” to ). In this
case the filtering cycle will start immediately.
X
Set the start delay (from a minimum of 9 to a maximum of 23)
using the key “Up/Down ” and confirm using the “ Light ”
key to save the entered value and exit from the programming
mode.
When this function is active, the LED of the respective symbol
will turn on.
If the LED is blinking, it means that the cycle has been
suspended, see the relative chapter for more information.
“Boost” - ( “hydro” and “hydro+blower” versions only)
This special type of filtering is recommended in special situations,
such as before or after a party with friends, or to facilitate dissolu-
tion of substances used for water disinfection.
X
To activate this function, press and hold down the “ Pump ”
key for 5 seconds. The display will show the message boo .
X
The operation lasts 45 minutes (this time period cannot be
modified) during which the pump is activated together with
Clearray™ (where present).
For details on filtering, refer to the product’s installation
manual.