J-200 Series
12.3 Pillow Care
Remove and clean each headrest by gently grasping both ends in each hand
and pulling upward to release each pillow “snap.” To reinstall, simply “snap”
each pillow back into place. Clean as needed with soapy water using a cloth or
soft-bristle brush. To maintain water resistance and luster, apply a quality vinyl
conditioner once a month. Always remove the pillows when adding chemical
shock treatment to the spa water. The headrests can be returned to the spa when
the sanitizer reading drops below 4 ppm.
12.4 Cleaning The Spa Interior
To preserve the sheen of your spa’s surface, it is crucial that you avoid using
abrasive cleaners or cleaners which have adverse chemical effect on the surface.
If you are not certain as to the suitability of a particular cleanser, consult your
authorized Jacuzzi dealer. Regardless of the cleanser used, use extreme care to
assure that no soap residue is left on the surface. This could cause severe sudsing
when the spa is refilled.
12.5 Maintaining the Cover
Using the Jacuzzi insulating spa cover anytime the spa is not in use will signifi-
cantly reduce your operating costs, heat-up time and maintenance requirements.
To prolong the life of the cover, handle it with care and clean it regularly using
mild soap and water. Periodic treatments with a special conditioner developed
for Jacuzzi spa covers will help protect against deterioration caused by UV rays
from the sun.
Never allow anyone to stand or sit on the cover, and avoid dragging it across
rough surfaces.
12.6 Maintaining The Synthetic Cabinet
Your new spa’s synthetic cabinet requires little or no maintenance of any kind.
To clean, simply wipe cabinet with a clean towel and mild soap solution.
CAUTION:
Never spray cabinet with a garden hose for any reason
since this action may induce an electrical short in the spa’s electrical
equipment..
12.7 Winterizing
Your Jacuzzi spa is designed to automatically protect itself against freezing when
operating properly. During periods of severe freezing temperatures, you should
check periodically to be certain that the electrical supply to the spa has not been
interrupted. In extreme, bitter cold weather less than -20°F (-29°C), choose the
F3 “Standard” filtration/heating mode to prevent freezing (page
do not intend to use your spa, or if there is a prolonged power outage during
31
Содержание J - 230
Страница 1: ...owner s manual J 2 0 0 S e r i e s J 280 J 270 J 230 J 220 J 210 2530 277T Rev A...
Страница 55: ......