CONTROLS 3
8
L.
2WD / 4 WD Switch - Forward
Sets tractor into two or four wheel drive. Tractor must
be in 4WD to operate cutting units.
Tractor returns to 2 WD when backing up unless
4WD reverse switch
(Z)
is pressed.
M.
Engine Throttle
Controls engine speed. Run machine at full throttle
when transporting machine.
Note:
Do not tamper with throttle stop lock.
N.
2WD / 4WD Switch - Reverse
Provides momentary 4WD in reverse
Press and hold switch down to shift into 4WD.
Machine returns to 2 WD when switch is released.
O.
Deck Levers
Raises and lowers decks. Decks can be raised or
lowered separately or together. When raising decks
hold lever back until deck is completely up. Levers
return to neutral when released.
P.
Down Pressure Control
Transfers weight between decks and tractor.
Turn control clockwise to reduce down
pressure on decks and transfer weight to
tractor. Reducing down pressure improves
traction but may cause decks to float causing an
uneven cut.
To increase down pressure on decks turn
control counterclockwise. This reduces
traction but improves deck contact with
ground.
Q.
Light Switch
(optional)
Controls operation of road and work lights.
R.
Warning Lights
Alerts the operator to conditions requiring immediate
action. See Section 3.3.
S.
Temperature Gauge
Indicates engine coolant temperature. Normal
operating temperature should be between 160° -
230°F (71°-110°C). If temperature rises above 230°
(110°F), alarm will sound. See Section 3.3.
T.
Fuel Gauge
Indicates current fuel level. Check fuel gauge daily
before starting machine.
U.
Hour Meter
Records engine operating hours. Use hour meter to
schedule periodic maintenance.
V.
Ignition Switch
The ignition switch has three positions. OFF-RUN
(ON)-START. In the run position the electrical
system is active. Turn to START to crank engine.
Always turn switch to OFF and remove key when
leaving machine.
W.
Hydraulic Oil Level Light
Alerts the operator of a low fluid level in
hydraulic tank. See Section 3.3.
Note:
The warning light will remain on as long
as a low oil level is detected. The light will come on
momentarily when first starting engine.
X.
Cruise Control
(Option)
When switched ON the cruise control will lock the
traction pedal in its current position. Cruise will
unlock when switched OFF, or if parking brake is
applied.
Y.
Power Take-off Switch
Provides power to cutting units. Tractor must be set
in 4WD
(L)
and decks lowered
(O)
for cutting units to
engage.
Figure 3C
K
Y
M
O
P
Q
R
S
T
U
V
W
X
L
N
HR002
Содержание HR 9016 Turbo
Страница 34: ...5 NOTES OBSERVACIONES 17 5 NOTES OBSERVACIONES...
Страница 35: ......
Страница 36: ...Textron Golf Turf Specialty Products PO Box 7708 Charlotte NC 28241 7708 www ttcsp com...
