Jacobsen ECLIPSE 360, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 67 / 148

B
MAINTENANCE
en-67 Safety, Operation, & Maintenance Manual
Lithium
LIFT ACTUATOR CALIBRATION _______________________________________
The actuators need to be calibrated at initial setup, whenever an actuator or the RCU was replaced, or when switching
from reels to vertical mowers.
Before calibrating, reels or vertical mowers must be properly set-up with rollers, and installed on the Eclipse mower.
To calibrate the actuators:
1. Park the mower on a flat and level surface.
2. Enter Maintenance Mode.
See Maintenance Mode on
page 29..
3. Press either of the orange buttons (AM or AN) on the
LDU until the ACTUATOR CALIBRATE? screen is on
the LCD display. Press the black button (AL) to enter set
mode.
4. With mow switch off, all three mower switches on, and
parking brake engaged, raise or lower all three reels until
the left reel is at the desired crosscut position. Crosscut
position may be measured by the distance actuator is
extended, or by measuring the distance from the ground
to the reel.
a. Press the left orange button (AN) on the LDU to save
the crosscut position for the left reel.
b. Raise or lower the center reel as required to match
the crosscut position of the left reel. Press the left
orange button (AN) on the LDU to save the crosscut
position for the center reel. Repeat for the right reel.
c. Lower all three reels until the left reel actuator pin (D)
is centered in the lift arm slot (C) . Save the lowered
position for the left reel.
d. Raise or lower the center reel as required until the
center reel actuator pin (D) is centered in the lift yoke
bracket slot (C) . Press the left orange button (AN) on
the LDU to save the lowered position for the center
reel. Repeat for the right reel.
NOTICE
Any changes made to settings in the Maintenance
Mode will not be active until the mower is powered
down and restarted.
NOTICE
To ensure all three reels lower and start cutting at
the same point, the crosscut
position should be the
same distance from the ground for each reel.
!
JACOBSEN
VERSION X.XX
AL AM AN
48 V
12 V
L CROSSCUT
SAVE QUIT SKIP
C CROSSCUT
SAVE QUIT SKIP
R CROSSCUT
SAVE QUIT SKIP
LEFT DOWN
SAVE QUIT SKIP
CENTER DOWN
SAVE QUIT SKIP
RIGHT DOWN
SAVE QUIT SKIP
ACTUATOR
CALIBRATE?
Set actuator
calibration
Set L actuator
one touch lift
point
Set C actuator
one touch lift
point
Set L Acuator
lowered point
Set C actuator
lowered point
Set R actuator
lowered point
Set R actuator
one touch lift
point