Jacobsen ECLIPSE 360, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 23 / 148

B
CONTROLS
en-23 Safety, Operation, & Maintenance Manual
Lithium
OPERATOR CONVENIENCE
MCU Access Panel (R)
Remove thumbscrew and lift up on front of access panel to view MCU diagnostic lights. Always secure access panel with
thumbscrew when operating.
Cup Holder (S)
Used to hold a beverage cup for the operator or may be used as additional storage pocket. Rubber portion of cup holder
is removable for cleaning purposes.
Storage Compartment (T)
Used to store gloves and other necessary protective items for the operator.
Step (U)
Used to assist operator entering or exiting the operator’s area.
Headlight (V)
Used to provide light when operating in the early morning or late evening. Light direction can be adjusted by the operator.
Pivoting Armrest (X)
Used to position armrest for operator comfort. Armrest will also pivot out of the way for entering or exiting on the right
side of the mower. Armrest can also be adjusted to three different heights.
Center Reel Swing Arm Service Latch (Y)
Used to secure center reel swing arm in service position.
Center Reel Swing Arm Handle (AA)
Used to move center reel out from under mower for servicing. Raise center mower, remove grass catcher, unlatch arm to
swing center reel out, and latch arm in service position (Y) . Do not operate mower without swing out arm securely latched
in closed position.
Running Light (AB)
Light located under operator seat to provide illumination of center mower and floorboard. Light is always on with the sys -
tem power switch (H) in the RUN position
Hood Latch (AC)
Lift handle up and rotate handle 180° counter-clockwise to unlatch hood. With hood closed rotate handle 180° clockwise
to latch hood. Keep hood latched when operating mower.