Jacobsen AR3, Техническое руководство по ремонту

Страница: 162 / 342

HYDROSTATIC POWER TRAIN
4181384 First Edition 5-15
5
Figure 5-14
6. Adjust flow lock tool (6) to allow pump to produce 10
gpm (37.8 lpm) in the forward direction.
7. Use the flow meter to warm the hydraulic oil. Turn the
flow meter valve (2) until a reading of 1525 psi (105
bar) or one half of the relief valve rating is reached.
Warm oil to 120—150°F (49—65°C), open valve fully
after operating temperature is reached.
8. After warming the hydraulic oil, verify flow lock tool is
adjusted to allow pump to produce 10 gpm (37.8 lpm)
in the forward direction.
9. Read and record no load flow.
10. Slowly close flow meter valve (2) until pressure
reaches 2300 psi (159 bar). Read and record loaded
flow.
11. Stop engine and return flow lock tool back to neutral
position.
12. Calculate traction pump leakage.
(Step 9 – Step 10 / Step 9 x 100 = Leak Percentage)
Is traction pump leakage 10% or less?
YES The traction pump is good. Proceed to step
13.
NO Proceed to next question.
Is traction pump leakage 11% to 20%?
YES The traction pump is marginal. Additional
testing is required. Continue to step 13.
NO Proceed to next question.
Is traction pump leakage 21% or more?
YES Repair or replace traction pump. (See
“Traction Pump” on page 5-22.)
!
CAUTION
13. Continue to close flow meter valve (2) until zero flow
is obtained. Record forward system relief valve
pressure.
14. Stop engine and return flow lock tool back to neutral
position.
NOTE
Reverse system relief valve test is similar.
15. To test reverse system relief valve, swap hoses (4)
and (5) at flow meter and adjust flow lock tool to 10
gpm (37.8 lpm) in reverse direction.
16. Close flow meter valve (2) until zero flow is obtained
and record reverse system relief valve pressure.
17. Stop engine and return flow lock tool back to neutral
position.
Is forward system relief pressure 3046 psi (210
bar)?
YES Forward system relief valve is good. Proceed
to step 18.
NO Replace forward system relief valve. (See
“Traction Pump” on page 5-22.)
Is reverse system relief pressure 3046 psi (210
bar)?
YES Reverse system relief valve is good. Proceed
to step 18.
NO Replace reverse system relief valve. (See
“Traction Pump” on page 5-22.)
18. If no further testing is required, disconnect and
remove test equipment. Install all hoses and fittings
as noted prior to removal.
19. Check hydraulic oil level. Add oil as needed. (Refer to
“Safety, Operation, and Maintenance Manual” for oil
specifications.)
6
TN1364
Do not exceed 3100 psi (214 bar) when testing
system relief valves or equipment damage may
occur.