7 ADJUSTMENTS
en-48
7.6
TRACTION PEDAL STOPS __________________________________________________
The traction pedal has three pedal stops to limit the speed of the
mower.
The forward transport speed stop (A) is used to set the maximum
transport speed. Make sure the mow speed lever (C) is in the
transport position. Loosen nut (B) and adjust the stop to set the
desired speed. Tighten the nut.
The forward mow speed stop (D) is used to set the maximum mow
speed. Rotate the mow speed lever (C) to the mow position. Loosen
nut (E) and adjust the stop to set the desired speed. Tighten the
nut.
The reverse speed stop (F) is used to set the maximum transport
speed. Loosen nut (G) and adjust the stop to set the desired speed.
7.7
FRONT REEL LIMIT SWITCH
The mower has a proximity switch (A), which signals the controller
to turn off the reels. The switch is installed on the mower frame
behind the center lift arm. If the reels continue to rotate when lifted
or do not rotate when lowered, inspect the switch. Adjust or replace
the switch as required. The proximity switch has a red LED to signal
when the switch contacts are closed.
To adjust switch:
1.
Park the mower on a flat and level surface.
2.
Remove the cutting unit from the center lift arm.
3.
Turn the ignition switch to the RUN position to activate the
controller. Do not run the reels or start the engine.
4.
Adjust the lift arm switch (A) as required to get an 1/8 to 3/16
in. (0.3 to 0.5 cm) air gap between the switch and the lift arm.
5.
Lift the arm with your hand until the lift arm (B) is at a 30° angle.
6.
With the lift arm at 30°, adjust the lift arm switch (A), until the switch contacts close and the red LED turns on.
Fasten the switch in this position.
7.
Start the engine and make sure that the reels turn off when lifted.
NOTICE
The proximity switch sets the point where the reels stop rotation. The reels will lift to a position more than 30°.
A
C
D
G
F
E
B
A
B
3
0°
Содержание 672256G01
Страница 96: ......
Страница 97: ...SPECIFICATIONS 12 en 95...
