ADJUSTMENTS 9
39
9.8
LIFT CYLINDERS __________________________________________________________
1.
Fully extend the front cylinder, then check spacing at
the cam roller
(U)
. The dimension should be 7/16 to
9/16 in. (11.1 to 14.2 mm).
2.
Loosen nut
(V)
then grip the very end of the cylinder
rod, close to the adjusting nut
(point W)
and turn
until spacing is correct. Tighten nut
(V)
.
3.
Loosen nut
(X)
on the rear lift cylinder. Adjust the rod
end
(Y)
until the lift arm
(O)
just touches the stop
bracket when the cylinder is fully retracted.
Figure 9H
Figure 9I
9.9
ANTISWAY SPRING ________________________________________________________
1.
The antisway spring
(C)
should be tight but not
under stress.
2.
Loosen both nuts on the adjusting rod then adjust the
rear nut as necessary.
3.
When properly adjusted, tighten nuts against bracket.
Figure 9J
7/16 to 9/16 in.
(11.1 to 14.2 mm)
V
W
U
GKV-8
GKV-9
Stop Bracket
X
Y
O
C
GKV 2
