Jacobsen 10029194, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 70 / 148

B
en-70
Safety, Operation, & Maintenance Manual
MAINTENANCE
Lithium
• Use only fresh water for cleaning your equipment.
• Do not spray water directly at the instrument panel, ignition switch, controller, or any other electrical components, or
at bearing housings and seals.
• Clean all plastic or rubber components with a mild soap solution and warm water, or use commercially available
vinyl/rubber cleaners.
• Repair damaged metal surfaces and use Jacobsen touch-up paint. Wax the equipment for maximum paint protec -
tion.
STORAGE __________________________________________________________
General
1. Clean the mower thoroughly and lubricate. Repair and paint damaged or exposed metal.
2. Inspect the mower, tighten all hardware, replace worn or damaged components.
3. Clean the tires thoroughly and store the mower so the load is off the tires. If mower is not on jack stands, check tires
at regular intervals and re-inflate as necessary.
4. Keep the machine and all its accessories clean, dry and protected from the elements during storage.
Cutting Units
1. Wash the cutting units thoroughly, then repair and paint any damaged or exposed metal.
2. Lubricate all fittings and friction points.
3. Backlap the reels then back the reel away from the bedknife. Apply a light coat of rust preventative oil to the sharp
-
ened edges of the reel and bedknife.
NOTICE
Use of salt water or affluent water has been known
to encourage rust and corrosion of metal parts
resulting in premature deterioration or failure. Dam -
age of this nature is not covered by the factory war -
ranty.
CAUTION
Clean grass and debris from cutting units, drives,
muffler, and engine to prevent fires.
WARNING
NEVER use your hands to clean cutting units. Use a
brush to remove grass clippings from blades.
Blades are extremely sharp and can cause serious
injuries.
!
!