Jacobsen 10029194, Руководство по безопасности, эксплуатации и техническому обслуживанию

Страница: 69 / 148

B
MAINTENANCE
en-69 Safety, Operation, & Maintenance Manual
Lithium
TIRES _____________________________________________________________
1. Keep tires properly inflated to prolong tire life. Check inflation pressure while the tires are cool. Inspect tread wear.
2. Check the pressure with an accurate, low pressure tire gauge.
3. Keep tires inflated to:
Front......................... 16 psi (1.1 BAR)
Rear.......................... 20 psi (1.3 BAR)
WHEEL MOUNTING PROCEDURE ______________________________________
1. Remove dirt, grease and oil from stud thread. Do not lubricate threads.
2. Position wheel on hub and inspect to insure full contact between mounting surface of wheel and hub or brake drum.
3. Finger tighten all hardware then torque hardware in criss-cross order; always tighten nuts in the top position.
4. Check and retorque daily until torque is maintained, 85-95 ft.lbs. (115-128 Nm)
CARE AND CLEANING _______________________________________________
Clean the mower and implements after each use. Keep the equipment clean. Whenever possible, use compressed air to
clean mower.
• Use compressed air to clean engine and radiator fins (30 psi (2.1 BAR) maximum).
NOTICE
Under inflated tires may leave tire marks in turf
.
For
soft turf, tire inflation pressure may need to be
increased to 22 psi (1.5 BAR).
CAUTION
Unless you have the proper training, tools and
experience, DO NOT attempt to mount a tire on a
rim. Improper mounting can produce an explosion
which may result in serious injury.
WARNING
Make sure the mower is parked on a solid and level
surface. Never work on a mower that is supported
only by the jack. Always use jack stands.
If only the front or rear of the mower is raised, place
chocks in front of and behind the wheels that are not
raised.
NOTICE
Do not wash any portion of the equipment while it
is hot. Do not use high pressure spray or steam.
Use cold water and automotive cleaners.
!
!