CARTON CONTENTS
JackRabbit
2.5 amp Battery Charger
Optional accessories could include:
Extended range 4.4 Ah battery pack
Rear cargo rack/basket
Shoulder carry sling
Phone carrier
Travel bag
Cup holder
Bell
ASSEMBLY INSTRUCTIONS
Your JackRabbit has been 99% pre-assembled and requires only a few steps
to get it ready to ride.
1. Remove all contents from the carton and record the serial number found
on the front of the head tube above the fork. If anything is damaged please
contact us immediately.
2. Insert the handlebar stem into its base until the silver button clicks in place
as illustrated here.
3. Press down the quick release lever to secure the stem
extension assembly to the stem base. If necessary
turn the thumb nut to adjust the clamp’s tightness.
4. Squeeze the hand brake lever to confirm that the
brake pads contact the rotor.
5. Set the saddle height so that both feet touch the
ground when seated.
6. Fold down the footrests.
7. Confirm the battery’s charge status by pressing the small button on top of
the battery pack. If only the red LED illuminates the battery is 25% charged
(30-33 volts) and should be recharged before riding. Thirty minutes of
charging will be enough to get going! (Power diminishes as voltage drops.)
2
2.5 amp fan-cooled Battery Charger
ASSEMBLY INSTRUCTIONS
3. Press down the quick release lever to secure the stem
2. Turn the front wheel 180 degrees, remove and save the vinyl cap then insert the
stem extension into its base until the silver button clicks into place as seen here.
extension assembly to the stem base. If necessary
turn the thumb nut to adjust the clamp’s tightness.
4. Confirm that the brake housing is seated in the barrel
adjuster then squeeze the lever to confirm operation.
Air Travel bag
Cup holder
Courtesy bell
Front & Rear fenders
Phone mount
4. Check that the brake housing is seated in the barrel
(30-33 volts). When all 4 LED's light up you are 100% charged. Power
output (speed) diminishes as the battery's charge drops from 42 to 30 volts.
the battery pack. If only the red LED illuminates the battery is 25% charged
2.5 amp fan-cooled battery charger
extension assembly to the stem base.
3. Press down the quick release lever to secure the stem
stem extension into its base until the silver button clicks into place as seen below.
2. Turn the front wheel 180 degrees, remove and save the retention clip then insert the
1. Remove all contents from the carton and record the serial number found
few steps to get it ready to ride.
ASSEMBLY INSTRUCTIONS
Custom alloy cup holder
Air Travel bag
Phone mount
Shoulder carry sling
Rear Utility rack-basket
Extended range 4.4 Ah battery pack
Optional accessories could include:
Spare inner tube, reflector kit & touch-up paint
USB Rechargeable LED lights
Front & Rear fenders
Courtesy bell
JackRabbit e-Glider
Your JackRabbit e-Glider has been 99% pre-assembled and requires only a
for future transport by air. If anything is damaged please contact us immediately.
on the front of the head tube above the fork. Save the 4 plastic axle nut covers
