Jack JK-SHIRLEYIIE, Руководство по эксплуатации и ежедневному обслуживанию

Страница: 8 / 18

Presser foot lifter
Thread tension device
Press and it can open or close small thread tension device easily
1. After the user press the ,and it press the at the same time,it will enter into system
parameter modification mode
2. P19:choose clamp thread function:(0:off,1:on)
P1A:Angle for clamping thread start
P1C:Angle for clamping thread finish
Bar tacking
Front reinforce stitching switch
Behind reinforce stitching switch
Technology source parameter modification mode
P13:the needle tracing compensation A for front reinforce stitching
P14:the needle tracing compensation B for front reinforce stitching
P15:the needle tracing compensation A for behind reinforce stitching
P16:the needle tracing compensation B for behind reinforce stitching
1. Press this button continuously, this function of auto-presser foot
lifter can be cycling switch between -“function on in middle
way/function off ”and -“function on after thread trimming and stop/
function off ”.Suitable for many different operation customs, and
different procedure of sewing demands.
2. Press and hold button ,press button at the same time ,
enter into “system programmer parameter mode”
4
P78-53revise as P78-200(solenoid full output strength time)
P79-05revise as P79-04(full output strength connect time)
P7A-05revise as P7A-06(full output strength disconnect time)
.
P44:Delay time of presser foot lifter down
This parameter is defined as the interval time between the presser lifter down
and the begin of sewing . the bigger of the numerical value ,the speed of starting,
sewing the smaller the numerical value , the speed of starting sewing is faster.
3. “system programmer parameter” P35: setting of presser foot lifter position
Needle positioning mode
When we swith on the power, If indicator light is off, it means needle up,
If indicator light is on, it means needle down
Note:
During stitching, if you want to change the needle positioning according to
your requirement,please stop the machine,make sure the pedal in the original
position, then press the needle positioning button to change as you want.
If indicator light is off
it means needle up If indicator light is on
it means needle down
The pedal is in the
original position
Needle Up Needle Down
Application of needle position
10 11